AirCooledNut.com

Home > Zoom-zoom > Ducati > Oberon clutch slave
Use an 8mm open-ended wrench to crack open the bleeder nipple when bleeding the clutch slave.  I used clear tubing, bungeed to the kick-stand, and let it drain into a glass container.  I bled my system until fresh fluid appeared.  Remember to keep an eye on the reservoir!  Oh yeah, you no longer need the plastic wrap cover.  When done, make sure the reservoir is about 3/4 full, then insert the rubber boot and secure the cap.

Use an 8mm open-ended wrench to crack open the bleeder nipple when bleeding the clutch slave. I used clear tubing, bungeed to the kick-stand, and let it drain into a glass container. I bled my system until fresh fluid appeared. Remember to keep an eye on the reservoir! Oh yeah, you no longer need the plastic wrap cover. When done, make sure the reservoir is about 3/4 full, then insert the rubber boot and secure the cap.

duc_006.jpg roof_helmet_009.jpg sprocket_sliders_019.jpg Oberon_010.jpg hypermotard_oil_line_013.jpg duc_015.jpg gauge_lowering_mounts_005.jpg