 Last additions - StompGrip |
255 viewsNotes: The instructions say to clean the area with brake cleaner and scuff the area. Because I'm using the TankSlapper to protect my tank I didn't do either but I did clean the area on the TankSlapper well.Jan 01, 2011
|
|
275 viewsHow it looks on the bike. Not as pretty as I had hoped but, man, does it work!Jan 01, 2011
|
|
282 viewsHere's the StompGrip on the tank. The adhesive backing is 3M and it is sticky! So get everything lined up, triple checked, then peel the backing off. Place the StompGrip inbetween the marks and get it right the first time because the stuff is STICKY!Jan 01, 2011
|
|
236 viewsPut the pattern on the back side of the StompGrip and trace the outline with a permanent pen. Then simply cut it with scissors. Following the instructions that come with the kit, make sure you have round corners.Jan 01, 2011
|
|
231 viewsCut the paper so you have a pattern. Tape it back to the tank, using the marks you placed earlier to property align it. Rub out the marks and put new ones down about 1/4" out. This will help when applying the StompGrip.Jan 01, 2011
|
|
235 viewsUsing a grease pencil to mark the tank where your outline is. This is to help place the pattern later.Jan 01, 2011
|
|
233 viewsTape some paper to the tank, sit on the bike, grip the tank, and trace around your legs.Jan 01, 2011
|
|
|
|
|
