 Most viewed |
779 viewsRemove the gas expansion tank.
|
|
776 views
|
|
775 views
|
|
769 viewsThe plug removed from the sending unit.
|
|
768 viewsRemove the other 10mm bolt from the left side of the expansion tank.
|
|
768 views
|
|
Side bar: Foggy breath guard767 viewsFor those who have a standard, full-face helmet and want to stop the fogging of their face shield then I cannot recommend enough the Foggy breath guard! I love it!!!
|
|
767 views
|
|
762 views198-Mb file size...this can take a few minutes to load! How to remove the tail light bulb holder. Also shows the LED tail light in action. It's faster/better if you use this: https://youtu.be/Bdp-jmCcNgk
|
|
760 views
|
|
758 views
|
|
754 viewsThe float is at the bottom of the sender assembly.
|
|
737 viewsSnug the nut down but don't over-tighten! Carefully bend the tabs back over the nut to keep it secure and from rotating. If that nut falls into the tank consider it gone and your outer tube will drop to the bottom of the tank and clunk around, possibly damaging the sender's wires!
|
|
736 viewsThe underside of the top of the sender assembly. The corrosion here wasn't as bad as the photo depicts.
|
|
735 viewsSender assembly easily comes out of the tank.
|
|
726 viewsLED, brake light mode. The light is spread out a LOT more.
|
|
725 viewsThe tab fits into the hole at the bottom of the assembly tube.
|
|
716 viewsBed bottom removed, exposing roof.
|
|
713 views
|
|
711 viewsFoam padding on ceiling in Bus. Maybe it's acting as insulation or if you sit up in the lower bed too fast it helps cushion the blow?
|
|
| 3333 files on 167 page(s) |
 |
6 | |
|
