| Category |
Albums |
Files |
|
|
23 |
555 |
|
|
9 |
103 |
|
|  | | RoninPictures of the little boy. |
|
4 |
60 |
|
| Type 3Dedicated to VW Type 3 stuff. |
|
28 |
482 |
|
| Zoom-zoomNon-Type 3 stuff. Ferrari, motorcycle, auto shows, and other gear-head stuff. |
|
12 |
590 |
|
| | | PorscheConcerning my 914 as well as the manufacturer. |
|
6 |
115 |
|
|
20 |
273 |
|
| | | How-toPictorials of how to do stuff, helper pictures, etc. |
|
13 |
228 |
|
| MiscEverything else goes in here. |
|
17 |
432 |
|
| | | My Navy DazeImages of my active service time in the US Navy, 1987-1990. Photographs are scanned because I was in the service before digital photography. |
|
2 |
6 |
|
| 2,844 files in 134 albums and 11 categories with 0 comments viewed 93,696 times |
 Last updated albums |
Ducabike sprocket cover4 viewsPrettier.Feb 04, 2012
|
|
A's birthday 20113 viewsDec 26, 2011
|
|
Heather & Kyles Wedding16 viewsDec 23, 2011
|
|
ROOF helmet158 viewsMan I love the look of this helmet! Wind noise is greatly reduced compared to my noisy HJC. The helmet doesn't feel like it's pressing around the ears so I can hear my bike better. One thing that was noticeable was the air entering the face area. There are vents in the chin bar that are always open so this helmet will be nice in warmer weather...not so nice in cold weather unless I wear a face mask. Wearing my sunglasses was easy in my HJC but they don't fit quite as straight in the ROOF.Jul 28, 2011
|
|
Hi-rise clip-ons install93 viewsHi-riser is slipped on the fork tube and here is the bar in stock form.Jul 03, 2011
|
|
Ducati voltage regulator/rectifier relocation370 viewsJun 01, 2011
|
|
Hypermotard oil line mod73 viewsThis is the end of the oil line that is connected to the output on the engine. Notice that goofy bend? That's what's needed for the line to clear the engine. The only tools needed are two 19mm open-ended wrenches, flat-bladed screwdriver, and a 5mm Allen wrench. Use one wrench to hold the connector nut and the other to remove/replace the oil line coupling nut.May 14, 2011
|
|
Making spark plug wires35 viewsThe 90-degree boot is on the wire and ready to be slid down. As per the instructions, just a spritz (very light coat) of WD-40 really helps move the boot down the wire.May 08, 2011
|
|
