 Last additions - Ducati |
440 viewsJust a picture of the stock '06 clip-ons and the bottom side of the upper triple tree.Jul 03, 2011
|
|
398 viewsIt seems that the locating pin on the '06 throttle clamp is 180-degrees off compared to later models. The fix was simple: Use a 5/32" drill bit and drill straight through the existing hole. Easy-peasy!Jul 03, 2011
|
|
429 viewsThe top bar has the stock groove in it and the bottom one shows the extra material I had to remove, about 3/4 of the width of the original groove. Both bars required this modification. This allows the bar to be positioned "down" more so the reservoir clamps/brackets can fit on the bars. I used a hack saw to make the initial removal of material then used a rat-tail (round) file to further remove material and neaten the curves. Remember to remove just a little instead of too much! These are aluminum and it's very easy to work with.Jul 03, 2011
|
|
440 viewsOther side of the right bar showing another locating hole.Jul 03, 2011
|
|
414 viewsRight side showing locating pin and hole.Jul 03, 2011
|
|
420 viewsOther side of the bar showing the locating pin and hole.Jul 03, 2011
|
|
498 viewsHi-riser is slipped on the fork tube and here is the bar in stock form.Jul 03, 2011
|
|
477 viewsUpper triple tree removed. Use a 6mm Allen wrench to loosen all clamping bolts. Alternately tap the bottom of the clip-ons to walk the triple tree and clip-ons up. I used a block of wood positioned under the clip-on and tapped it with a rubber mallet -- just in case I missed the wood!Jul 03, 2011
|
|
470 viewsDetail of the top triple tree with stock clip-ons.Jul 03, 2011
|
|
465 viewsDetail of the bottom of the unbolted ladder.Jul 03, 2011
|
|
475 viewsMy fingers are pointing to the two pins that fit into the two rubber grommets that are part of the upper triple tree (visible in the foreground).Jul 03, 2011
|
|
478 viewsIn order to remove the upper triple-tree the headlight needs to be removed and then the U-shaped ladder part that the headlight attaches to is then removed. Remove the two nuts at the bottom of the ladder then lift it up. Also, disconnect the headlight connector and put the headlight out of the way.Jul 03, 2011
|
|
Before...420 viewsThe bottom of the switch housing is at 34".Jul 03, 2011
|
|
Before...486 viewsYard stick shows 32" at bar-end mirror mount.Jul 03, 2011
|
|
Before...415 viewsJul 03, 2011
|
|
Before...484 viewsJul 03, 2011
|
|
Before...483 viewsJul 03, 2011
|
|
Before...557 viewsJul 03, 2011
|
|
Before (stock clip-ons)...633 viewsJul 03, 2011
|
|
1894 viewsSpace is now available. I'll be using this to house my Dynojet PowerCommander III.Jun 01, 2011
|
|
| 428 files on 22 page(s) |
 |
10 | |
|
