 Most viewed - Ohlins rear suspension install |
523 viewsI used the top of the hole in the bolt where the Allen wrench entered.
|
|
Done!519 views
|
|
517 viewsI used my engine hoist to lift my bike by the frame. I'm so glad I have this! This was necessary to get the full extension sag measurement as well as lifting the bike to take pressure off the lower bolt so it could be removed.
|
|
509 viewsLower bolt. Use a 10mm Allen wrench to remove the bolts. Though they already have molyb (grease B using Ducati nomenclature) smeared on them I (later) added a little bit more.
|
|
Detail 1477 viewsOEM Sachs on top (black spring) and Ohlins racing on the bottom (yellow spring).
|
|
Detail 3465 viewsThe Ohlins shock (left) has an adjustable lower mount as seen by the blue locking nut and threads.
|
|
Detail 2464 viewsThe Ohlins shock has more threads for more adjust-ability, likely for the range of springs it can accommodate.
|
|
457 viewsThere's a indentation in the seat pan that my tape measure consistently fit nicely in.
|
|
|
|
