 Most viewed |
613 viewsUnder the pedal area. The section behind it isn't insulated yet...
|
|
...after.613 views
|
|
613 viewsHow the HID bulb looks when installed. It can only go in one way so it's pretty easy. Don't do it now as we need to get the electronics installed first!
|
|
612 viewsThe bulb connector pulls straight off. Notice that it is one unit. The high-beam bulb has one connector on the bulb and a separate one on the bulb holder. The high-beam bulb is also smaller. Thus it's easy to determine which bulb is which. However, to give yourself some additional maneuvering room, you may want to disconnect the high-beam connectors and remove the high-beam bulb as well.
|
|
611 viewsJust a back-side shot of the 12mm bolts poking out the back. 10mm would be the perfect size but the hardware store I went to didn't have that size. The bolts should be M8x10 with 1.25mm thread pitch.
|
|
610 views
|
|
610 viewsWhat it looks like under the dash when put back together. The resistors aren't touching anything and there's no tension on them.
|
|
609 viewsOut and resting on wood blocks.
Minimum engine/tranny dimensions for space needed are:
Width = 43"
Height = 21"
Length = 25" for engine
= 48" for engine and tranny
= 55" for engine, tranny and muffler
|
|
609 viewsTodd in the Motocorsa van getting ready to unload 992cc of joy!
|
|
606 viewsHow it looks from the driver's point of view. Looks stock!
|
|
606 viewsBottom covered, LED and top uncovered.
|
|
605 viewsRight fog light installed, front view. Note that adjusting screw is always at the top.
|
|
604 viewsA sign of things to come.
|
|
604 viewsAfter Jacob's Squareback whips itself and the truck towing it 180° and ends up off the side of the road. ODOT shows up to see what happened (and the police showed up a few minutes later).
|
|
603 viewsThe new belt upper mount attached.
|
|
603 viewsEngine lowered and pulled back a little so left axle can be maneuvered to the top of the starter.
|
|
Day 1: Friday603 viewsThe Oregon contingent lined up and ready to invade!
|
|
602 viewsKen and I wait for the crew to unbolt the Square's CV joints and turn it around. It took them about two beers to finally get back on the road.
|
|
602 viewsRaw handle bar. Removing the left side is easy. Squirt some Windex(R) under the grip to help loosen its "grip" and make it easier to slip off.
|
|
601 viewsI just HAD to take her for a buzz around the block and since I'm used to my Goldwing I hit the throttle a tad too much and lifted the front...
|
|
| 3332 files on 167 page(s) |
 |
16 | |
|
