 Most viewed |
409 viewsAntonette running out to hug the ocean.
|
|
409 views
|
|
409 views
|
|
409 viewsMuch better, now they're eatting :-)
|
|
409 views
|
|
409 viewsAntonette next to a Lotus. Nice looking cars.
|
|
409 views
|
|
409 viewsI used the supplied double-sided tape to mount the electronics under the cosmetic cover. If you do this make sure you clean the mounting surfaces with rubbing (isopropyl) alcohol.
|
|
409 views
|
|
408 viewsJohn's girl.
|
|
408 viewsThe DDBers, along with my baby.
|
|
408 viewsNew firewall shifter bushing installed (soak in BOILING HOT WATER for ~30-60 seconds, place in hole, put a 24mm socket against it, and hit with hammer). The vice-grips greatly helped get the cabin shift rod into the under-engine shift rod joint.
|
|
408 viewsChubba-Lubba opening his Christmas present all on his own...
|
|
408 viewsI'm not a fan of the spare tire on the nose but I guess it's better than in the stock spare tire well at the rear of the cabin.
|
|
408 viewsYep, proof I was there.
|
|
408 views
|
|
408 views
|
|
408 viewsThe original bulbs came with a plastic ring to help hold them in their shipping case. I split it and put it behind the bulb, then carefully pushed the bulb retaining tangs onto the plastic ring. This kept the tangs more even. Without them you'll need to push the tangs down a little bit as well as bend them inward in order to retain the bulb. I oriented the bulb just like the halogen it replaced, tab pointing up. No shadows were cast, full light is output.
|
|
408 views
|
|
408 views
|
|
| 3332 files on 167 page(s) |
 |
75 | |
|
