 Most viewed |
361 views
|
|
361 viewsI put a rag under the cabin shift rod to make it easier to maneuver when I had to put it back into the firewall bushing. Not really necessary if you have skinny fingers like me.
|
|
361 views
|
|
361 views
|
|
361 viewsView from our balcany on the 4th floor, looking northward.
|
|
361 viewsThe grave yard...
|
|
361 viewsOne big totem.
|
|
361 viewsOn the left was our server and opposite is her husband.
|
|
Before and after - street view361 viewsBefore - Low beams, standing next to the B-pillar and looking forward.
|
|
361 viewsI used the supplied double-sided tape to mount the electronics under the cosmetic cover. If you do this make sure you clean the mounting surfaces with rubbing (isopropyl) alcohol.
|
|
361 viewsSheet of plywood with carpet glued to it removed. Exposed are additional plywood pieces that everything is screwed into. Note that these pieces of plywood are screwed to the Bus floor. I really don't think it's necessary but luckily only a couple screws were used.
|
|
361 viewsAll wood removed, exposing the bare Bus floor. Thank goodness rust was very, very minimal!
|
|
361 views
|
|
361 views
|
|
360 viewsBella licking another monkey's foot.
|
|
360 views
|
|
360 views
|
|
360 views
|
|
360 viewsMost of the Type 3's that were next to the DDB group.
|
|
360 viewsThe left side is a pain in the neck, getting the CV past the starter, but mostly because it's greasy and just slows down the process as you wiggle back and down, back and down...
|
|
| 3332 files on 167 page(s) |
 |
80 | |
|
