 Most viewed |
348 views
|
|
The Day After348 viewsBack to ordinary life :-(
|
|
348 views
|
|
348 views
|
|
348 views
|
|
348 viewsGlowing corals.
|
|
348 viewsPut tape around the headlamp to protect the paint. I initially used a battery-powered drill (pictured) but the battery was low on charge so I switched to my 6-amp drill. Locked the trigger on and started polishing. Very easy to do and I overlapped per the instructions, moving roughly a half-inch, back-n-forth across the headlamp then some lesser work on the turn signal area (it wasn't as badly pitted).
|
|
Before and after - facing vehicle348 viewsBefore - Low beams, facing vehicle.
|
|
348 views...use a hole saw or reamer to enlarge to 7/8" diameter. This is where the gasket will mount and allow the wires to pass through.
|
|
348 views
|
|
Close-up348 viewsNo sprocket cover.
|
|
348 views
|
|
348 views
|
|
348 views
|
|
347 viewsAntonette's favorite Ferrari, the Dino 246.
|
|
347 viewsMe oogling 12 cylinders.
|
|
347 viewsJohn Jaranson (composite engineer for Ford in Michigan) giving a tech session on composites, including carbon fiber.
|
|
347 viewsIt's all a matter of backing the tranny out, lowering it a little, backing it out, lowering it a little, backing it out, etc.
|
|
347 viewsJeep Hurricane. Two 5.7 engines (one front, one back) and front/rear steering. Approach/departure angles of 67/87 degrees. Carbon fiber body. 0-60mph < 5 seconds!
|
|
347 views
|
|
| 3332 files on 167 page(s) |
 |
92 | |
|
