 Most viewed - Type 3 |
614 views
|
|
609 viewsJust a back-side shot of the 12mm bolts poking out the back. 10mm would be the perfect size but the hardware store I went to didn't have that size. The bolts should be M8x10 with 1.25mm thread pitch.
|
|
603 viewsHow it looks from the driver's point of view. Looks stock!
|
|
601 viewsThe new belt upper mount attached.
|
|
Day 1: Friday600 viewsThe Oregon contingent lined up and ready to invade!
|
|
599 viewsAfter Jacob's Squareback whips itself and the truck towing it 180° and ends up off the side of the road. ODOT shows up to see what happened (and the police showed up a few minutes later).
|
|
596 viewsJust a reference of how the upper mount should look when the new one goes in.
|
|
596 viewsKen and I wait for the crew to unbolt the Square's CV joints and turn it around. It took them about two beers to finally get back on the road.
|
|
594 viewsAll stretched out and ready for a bath. Scrub both sides gently in hot, soapy water. Rinse both sides in fresh, hot water.
|
|
594 views
|
|
592 viewsDrying in the sun shine.
|
|
592 viewsHere is Per trying an American beer while Tommy Fat Cheeks waits patiently for a cheek scratchin'.
|
|
591 viewsEagle-eye Per spots a treasure behind the Chevron gas station…
|
|
590 viewsCovers the torso and lap (or gut) for any size occupant.
|
|
589 views
|
|
587 viewsOriginal AM radio.
|
|
586 viewsHow I attached the lower outside mount to the bracket. Slowly snug the bolt down until you can't move the belt's lower outside mount, then back of about 1/2 a turn, just so it can move with minor effort.
|
|
582 viewsHow my case breather is being used. Only one line from the breather and it dumps case over-pressure into the top of the carb.
|
|
581 viewsFits just like the stock unit in my baby! Really, I am more comfortable than I look. Honest :-)
|
|
579 viewsRaul taking full advantage of the sleeping space available in his Square.
|
|
| 482 files on 25 page(s) |
2 |  |
|
|
