 Last additions - Routan LED eyebrows |
416 viewsThis shows just how much the head lamps are angled on top. The left side has the LED array far back (towards the engine) whereas on the right side I wasn't as accurate and the LED array is about 3mm-5mm more forward (away from the engine). This clearly shows how the lip on the head lamp disburses the light. The left side is what I was originally looking for so I should've been more patient when installing the right side. Experience gained.Apr 16, 2012
|
|
385 viewsLow beams on.Apr 16, 2012
|
|
383 viewsOEM DRL on.Apr 16, 2012
|
|
342 viewsParking lights on.Apr 16, 2012
|
|
332 viewsLow beams on.Apr 16, 2012
|
|
367 viewsParking lights on.Apr 16, 2012
|
|
350 viewsApr 16, 2012
|
|
347 viewsWith low beams on. Very visible from the sides.Apr 16, 2012
|
|
374 viewsJust after sunset. At the time I took these pictures it was brighter out than what appears in the images. The LEDs are bright enough to the camera that it used a faster shutter speed, thus making the image look darker than it really is.Apr 16, 2012
|
|
377 viewsFacing into the sun, the LEDs can still be seen although they aren't as bright as dedicated OEM units found on other vehicles.Apr 16, 2012
|
|
355 viewsIn the shade.Apr 16, 2012
|
|
All done!373 viewsLights on. I took this picture with the flash to dim the LED array as they are very bright.Apr 13, 2012
|
|
363 viewsRouting the power feed wire along an existing loom.Apr 13, 2012
|
|
361 viewsThe red wire in the background is the turn signal tap while the white wire in the foreground is the feed to the DRL array.Apr 13, 2012
|
|
343 viewsJust a close-up of the power feed from the relay box tapped into the main power feed line that goes between the DRL LED array. The connector that's connecting white wire to red wire is what's feeding the DRL LED array.Apr 13, 2012
|
|
345 viewsShowing the finished wiring.Apr 13, 2012
|
|
373 viewsJust testing the left DRL LED array directly to the relay box. Used the camera flash to 'dim' the LEDs so they wouldn't wash out the picture. They are so bright that it can be seen that they are on.Apr 13, 2012
|
|
350 viewsFeed the power feed wire through the grommet and crimp on the connector. It should be snug in order to keep moisture and dust out.Apr 13, 2012
|
|
357 viewsThe fuse tab plugged in and with the stock 20A fuse in the BOTTOM. The top fuse will be a 1A to 3A item -- what ever is the smallest I can find -- since the LED array doesn't pull an appreciable amount of current.Apr 13, 2012
|
|
351 viewsStock 20A fuse removed and put in its new home.Apr 13, 2012
|
|
|
|
