 Most viewed - HPA starter |
410 viewsSince there is no notch to hold the retaining bolt I welded on a tab. It keeps the bolt from rotating when removing/applying the retaining nut.
|
|
406 viewsFront comparison.
|
|
403 viewsSolution: 1/8" cork gasket with a 1/16" stainless-steel washer under each mounting ear. This is a spacer, not really a gasket. The gasket material is used to hold the washers (well, along with some Gas-A-Cinch) and help prevent the mounting ears from getting torque stress during starting.
|
|
402 viewsComparison of the high-torque HPA starter on the left vs. the stock unit on the right.
|
|
389 viewsRear comparison. Notice that the wiring terminals are in a different location. Doesn't affect installation.
|
|
388 viewsAnother view of the interference wear.
|
|
385 viewsWear on original starter. Plus it wouldn't start when it got hot (heat soaked) and even when cold it cranked a bit slowly.
|
|
383 viewsAnother shot.
|
|
377 viewsAnother shot & ready to go into the yellow 914 you see in the background :-)
|
|
367 viewsArrows show wear on new HPA starter. Was making an odd, metalic buzzing sound during start testing after install. Removed and saw that the starter was engaging too far and thus rubbing against the flywheel.
|
|
352 viewsWear on original starter.
|
|
|
|
|
